PDC-03 EvoDry PD / RD

1. current moisture content

• Displays the current moisture content. Not adjustable.

2. current temperature

• Displays the current temperature of the process air. Not adjustable.

3. Hygrostat:

• Maximum desired moisture content (RF%).

4: Fan control:

Operating modes 2 and 3 (fan stop) are not available as of software version 5.6

• Mode 1 Means that the fan runs continuously even when dehumidification is not taking place.
• Mode 2 Means that the fan also stops when the moisture content is below the set value.
  Every 4 hours, the fan starts and runs for 15 minutes to check the moisture content.
• Mode 3 Means that the fan also stops when the moisture content is below the set value.
  Every 12 hours, the fan starts and runs for 3 minutes to check the moisture content.

During the time when the fan is stopped, no new values for humidity and temperature are read, this means that the dehumidifier never starts dehumidifying during the stop time.

5. humidity control:

• Mode 1 Dehumidification is constantly running without control via hygrostat.
• Mode 2 The built-in hygrostat controls the dehumidifier to achieve the set relative humidity.
• Mode 3 Economy mode, in this mode the dehumidifier is controlled by both temperature and relative humidity.

6. dehumidification in progress:

• Indicates whether dehumidification is in progress or not. Not adjustable.

7. climate alarm:

• Number of days that the moisture content may be above the alarm curve (red) before the climate alarm is cancelled.

8. filter alarm:

• Number of months between filter alarms

9. Launch sequence:

• Start-up sequence: dehumidification continues continuously for the number of days set in the parameter. The start-up sequence then ends and normal control begins.

30. Programme version control panel:

• Displays the current software version on the control panel. Cannot be adjusted.

31. Programme version processor board:

• Displays the current firmware version on the processor board. Not configurable.